Salamander Reservoir: Installation on a Wet Sprinkler System

Salamander Reservoir: installation on a wet sprinkler system

Step 1: Preparation for Installation

Recommended installation begins after a sprinkler technician has installed a nipple, ball valve and plug to receive the Salamander Reservoir.

Salamander Reservoir: installation on a wet sprinkler system

Step 2: Attach the Salamander Reservoir

Leave the ball valve between the system and the Salamander Reservoir in the closed position and attach the Salamander Reservoir.

Be sure to leave the Salamander Reservoir’s ball valve slightly ajar before beginning Step 3.

Salamander Reservoir: installation on a wet sprinkler system

Step 3: Bleed the Air from the Reservoir

Slowly open the ball valve between the system and the Salamander Reservoir about a quarter of a turn. This will allow the reservoir to fully fill with water, and bled out any air from the system.

Once water has bled out of the bleed valve for a few seconds, close the ball valve on the Salamander Reservoir, and screw in the ball valve plug.

The Reservoir is now full of water, and at equal pressure to the rest of the sprinkler system.

salamander_install_wet_02

Step 4: Final Positioning

Fully open the ball valve between the system and the Salamander Reservoir and ensure connectivity between the sensor and the gateway.

 

#buildings #salamanderreservoir #facilitymanagers #fireprotection #IoT #IOTtuesday #salamanderreservoir #sprinklerssavelives #proptech #putasalamanderinthesystem